Home Safety

This project helps the user to know the current status of the house through a web server. The user is provided with information on the status of unauthorized access, flame detection and gas leakage.
components
Hardware Components
Arduino UNO R3
X 1
Arduino Ethernet Shield
X 1
Gas Sensor (MQ2)
X 1
Small breadboard
X 1
Router
X 1
PIR Sensor
X 1
Flame Sensor
X 1
details

그림2.jpg

Step 1: Interfacing PIR Sensor With Ethernet Shield

Circuit Connections:

  1. First of all place the Arduino Ethernet shield on the top of Arduino Board.
  2. Connect the PIR sensor Signal pin to the digital pin 2 on the Arduino Ethernet shield using male to female connecting wire.
  3. Take one male to male wire, connect one terminal of wire to the +5V of Arduino Ethernet Shield and other terminal of the wire on the Breadboard.
  4. Take a male to female wire, connect 1 terminal where 5V pin of the Arduino is connected on the breadboard and the other terminal of the wire to the Vcc pin of PIR Sensor.
  5. Take a male to female wire, connect 1 terminal to the GND pin of the Arduino Ethernet Shield and the other terminal of the wire to the GND pin of PIR Sensor.

    Step 2: Interfacing Flame Sensor With Ethernet Shield

Circuit Connections:

  1. Connect the Flame Sensor D0 pin to the digital pin 3 on the Arduino Ethernet shield using male to female connecting wire.
  2. Take a male to female wire, connect 1 terminal where 5V pin of the Arduino is connected on the breadboard and the other terminal of the wire to the VCC pin of Flame Sensor.
  3. Take a male to female wire, connect 1 terminal to the GND pin of the Arduino Ethernet Shield and the other terminal of the wire to the GND pin of Flame Sensor.

 

Step 3: Interfacing Gas Sensor With Ethernet Shield

  1. Connect the Gas Sensor A0 pin to the Analog pin A0 on the Arduino Ethernet shield using male to female connecting wire.
  2. Take a male to female wire, connect 1 terminal where you connected 5v pin of the Arduino on the breadboard and the other terminal of the wire to the Vcc pin of Gas Sensor.
  3. Take a male to female wire, connect 1 terminal to the GND pin of your Arduino Ethernet Shield and the other terminal of the wire to the GND pin of Gas Sensor.

Step 4: Upload the Arduino Sketch

documents
Code
www.instructables.com

COMMENTS

Please Login to comment
  Subscribe  
Notify of
POSTED BY