Hs-nm5300a module integrates W5300 with necessary peripheral devices on a circuit board to provide customers with convenient applications.1. It maintains all functions and performance of W5300;2. Connect W5300 with MCU and lead out the power supply through the pin arrangement;3. Rj-45 internal integrated network transformer, the network cable can be directly connected to the module;4. The indicator light on rj-45 can indicate the Ethernet connection status of W5300;5. Dc 3.3v power supply;6. Strict aging test ensures high quality of products.
Supports hardwired TCP/IP protocols : TCP,UDP,ICMP,IPv4,ARP,IGMPv2,PPPoE,Ethernet - Supports 8 independent SOCKETs simultaneously - High network performance : Up to 50Mbps - Supports hybrid TCP/IP stack(software and hardware TCP/IP stack) - Supports PPPoE connection (with PAP/CHAP Authentication mode) - IP Fragmentation is not supported - Internal 128Kbytes memory for data communication(Internal TX/RX memory) - More flexible allocation internal TX/RX memory according to application throughput - Supports memory-to-memory DMA (only 16bit Data bus width & slave mode) - Embedded 10BaseT/100BaseTX Ethernet PHY - Supports auto negotiation (Full-duplex and half duplex) - Supports auto MDI/MDIX(Crossover) - Supports network Indicator LEDs (TX, RX, Full/Half duplex, Collision, Link, Speed) - Supports a external PHY instead of the internal PHY - Supports 16/8 bit data bus width - Supports 2 host interface mode(Direct address mode & Indirect address mode) - External 25MHz operation frequency (For internal PLL logic, period=40ns) - Internal 150MHz core operation frequency (PLL_CLK, period=about 6.67ns) - Network operation frequency (NIC_CLK : 25MHz(100BaseTX) or 2.5MHz(10BaseT)) - 3.3V operation with 5V I/O signal tolerance - Embedded power regulator for 1.8V core operation
how to use