Internet Presence Simulator (for Home)
NearBus is a Cloud Connector that allows you to fully integrate in the cloud different MCU platforms (like Arduino, OpenPicus, etc.) in a very easy and transparent way.
Arduino Nano with Ethernet Shield
He seems to have a lot trial & error when he connected and tested Arduino Nano board with Ethernet Shield. This is a good reference to anybody who makes a similar project as his intstructable.
“Autohome” – a web-based GUI for Arduino-powered Home Automation
The Arduino platform lends itself well to getting into the world of home automation (check our SuperHouse.tv) and many enthusiasts have created their own systems. However one home system by Arduino forum member OhmMega is of interest due to the controls and possibilities.
Agentuino – A lightweight SNMP Agent for Arduino Platforms
Agentuino is a lightweight Simple Network Management Protocol (SNMP) Agent library for the Arduino platforms supporting SNMP Version 1.
WAVEbuoy – lamp alarm for wave height
The WAVEbuoy is a arduino lamp connected to the internet that displays the current wave height of any of the National Data Buoy Center’s wave buoys
Arduino and Raspberrypi collaboration for motion detection
This post show about motion detector. The Arduino uno and Ethernet shield board is detect the motion. The data transmit raspberry pi via Lan that it operate the API inside …
E-blocks internet board
Matrixtsl makes the E-block board series with many kind MCU such as PIC, AVR and ARM and provides them. One of them is Eblock internet board which provides the internect connectivity with W5100 and WizFi610 of WIZnet Products.
How to measure Arduino network performance
This is a procedures for measuring the network performance data of Aruidno to check a bandwidth budget for new IoT Project.
ARDUINO WEB ENABLED AQUARIUM CONTROLLER
The idea was to create a controller for an aquarium, to measure temperature, measure water level and to turn pumps, heaters and lights on/off based on measurements and times.
LightControl
The author had 2 remote controllers to control 6 outlets in his apartment. He wanted to remove the remote controllers and control the light with his i-phone. Just by using Arduino & Ethernet shield, he made his own controller.