int blue = 9; // Define Digital Pins for each colour of the LED int green = 10; int red = 11; int redPot = A0; int greenPot = A1; //Define Analog Pins for the 3 potentiometers int bluePot = A2; int greenVal = 0; //Create a variable to store the state of each Potentiometer int blueVal = 0; int redVal = 0; const int BUTTON = 7; //Define the button Pin int state = 0; //Create a variable to store wether button is on or off int val = 0; //Create a variable to store the momentary state of the button int old_val = 0; //create a variable to store the previous state of the button void setup() { // put your setup code here, to run once: pinMode(green, OUTPUT); //Set LED's as output's, button as input pinMode(blue, OUTPUT); pinMode(red, OUTPUT); pinMode(BUTTON, INPUT); Serial.begin(9600); } void loop() { // put your main code here, to run repeatedly: Serial.begin(9600); //Open the serial monitor at 9600 baud val = digitalRead(BUTTON); // Check state of button if ((val == HIGH) && (old_val == LOW)) { //Check to see if state of button has changed state = 1 - state; //Set the button as either on (1) or off (0) delay(10); } old_val = val; // Save the previous button reading to compare next time through loop greenVal = analogRead(greenPot); //Read the position of the potentiometers blueVal = analogRead(bluePot); redVal = analogRead(redPot); if (state == 1) { //If button is on, set the state of each LED according to position analogWrite(green, greenVal / 4); //of its correspoding potentiometer. Anolog inputs range from 0-1023, analogWrite(blue, blueVal / 4); // while anolog outputs as PMW can be from 0-255. Therefore we must analogWrite(red, redVal / 4); // divide the potentiometer readings by 4 to set the state correctly Serial.print("RGB("); Serial.print(redVal/4); Serial.print(","); Serial.print(greenVal/4); Serial.print(","); Serial.print(blueVal/4); //Print the RGB Code, resuable in any RGB application Serial.println(")"); delay(50); } else { // If button is off, set all LED's to LOW/off analogWrite(green, 0); analogWrite(blue, 0); analogWrite(red, 0); delay(50); } }